ATV Parts Connection Logo
America's Connection for ATV Parts
Monday–Friday: 8am–6pm & Saturday: 9am–3pm EST
800-338-2326
Monday–Friday: 8am–6pm
Saturday: 9am–3pm EST

Inner CV Joint Disassembly

Step 1

To remove an inner CV joint from an CV axle, first cut off the old boot. If the boot is fine, and you want to reuse it, just pull it back towards the outer joint. After the boot is out of the way, clean any excess grease.

CV joint with boot

Step 2

Once it is clean, you should be able to look inside the inner joint housing and see a "c" clip near the edge of the housing.

Cleaned inner joint

Step 3

This can be removed by putting an utility knife or an flat head screw driver under the clip and flicking it off.

C clip on inner joint

Step 4

Once the clip is removed, you can pull off the inner joint housing, and whats left on your shaft should be: the race, the cage, and the ball bearings.

Removed shaft

Step 5

If you look at the top on the race, you'll see a retaining clip. If you have retaining clip pliers, this can be removed easily. Spread open the clip and remove it, that will allow you to remove the race, cage, and ball bearings off the shaft.

Removed cage and race

ATV Parts Connection, Monster Performance Parts, the Monster Axle logo, and ATV Parts Connection graphics are the servicemarks, trademarks, or registered trademarks owned by ATV Parts Connection. All other servicemarks and trademarks are the property of their respective owner.

[ Terms of Service ] [ Privacy Policy ]